Configure Maximum NEAP Clients
About this task
Use this procedure to configure the maximum NEAP clients allowed on the port at one time.
Procedure
Example
Configure the maximum NEAP clients allowed on the port at one time.
Switch:1>enable Switch:1#configure terminal Switch:1(config)#interface gigabitEthernet 1/1 Switch:1(config)#eapol multihost non-eap-mac-max 10
Variable Definitions
The following table defines parameters for the eapol multihost non-eap-mac-max command.
Variable |
Value |
---|---|
<0–8192> |
Specifies the maximum NEAP clients allowed on the port at one time. The default is 2. |