Enable Energy Saver on Ports
About this task
Perform this procedure to enable Energy Saver on a specific port or range of ports.
Note
Energy Saver does not operate on the 5720 Series when you configure local port Auto-Negotiation advertisements to 2500-full or 5000-full.
Before you begin
-
If you have previously enabled Energy Saver globally, you must disable it globally before enabling Energy Saver on individual ports.
-
If you have previously enabled Efficiency Mode, you must disable it before enabling Energy Saver on individual ports.
Procedure
Example
Enable energy savings on slot 1 port 2:
Switch:1>enable Switch:1#configure terminal Switch:1(config)#interface GigabitEthernet 1/2 Switch:1(config-if)#energy-saver port 1/2 enable
What to do next
Configure an Energy Saver schedule.
Variable Definitions
The following table defines parameters for the energy-saver command.
Variable |
Value |
---|---|
enable |
Enables energy savings on ports. The default is disabled. |
{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} |
Identifies the
slot and port in one of the following formats:
|