Create an IPv6 VPN Instance
Before you begin
The VRF must exist.
About this task
Create an IPv6 VPN instance to advertise IPv6 routes from a VRF to Shortest Path Bridging MAC (SPBM) network. For more information about Layer 3 Virtual Services Networks (VSNs) and SPBM, see Layer 3 VSN Configuration.
Procedure
Example
Create and enable IPv6 VPN instance:
Switch:1>enable Switch:1#configure terminal Switch:1(config)#router vrf vrfred Switch:1(router-vrf)#ipv6 ipvpn Switch:1(router-vrf)#i-sid 100 Switch:1(router-vrf)#ipv6 ipvpn enable Switch:1(router-vrf)#show ipv6 ipvpn ========================================================================================== IPv6 IPVPN ========================================================================================== VRF Name VRF ID IPv6 IPVPN IPv4 IPVPN I-SID I-SID Name ------------------------------------------------------------------------------------------ vrfred 2 enabled disabled 5555 ISID-5555 ------------------------------------------------------------------------------------------ 1 out of 1 Total IPv6 L3 VSN, 1 active IPv6 and 0 active IPv4 displayed.
Variable definitions
Use the data in the following table to configure the ipv6 ipvpn command.
Variable |
Value |
---|---|
enable |
Enables IPv6 IPVPN. The default is disabled. |
Use the data in the following table to configure the i-sid command.
Variable |
Value |
---|---|
<0–16777215> |
Assigns an I-SID to the VRF being configured. |
Use the data in the following table to configure the show ipv6 ipvpn command.
Variable |
Value |
---|---|
vrf WORD<1–16> |
Specifies the VRF name. |
vrfids WORD<0–512> |
Specifies the VRF ID. |