Associate VLANs with an ACL
Associate VLANs with an ACL to apply filters to VLAN traffic.
A VLAN can be part of two different ACLs of different types: IPv6 and non-IPv6.
Before you begin
The ACL exists.
Procedure
Variable definitions
Use the data in the following table to use the filter acl vlan command.
Variable |
Value |
---|---|
<1-2048> |
Specifies the ACL ID. |
<1-4059> |
Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. |