Configure LLDP-MED Emergency Call Service Location
Perform the following procedure to configure emergency call service location of local LLDP-MED on specific ports.
About this task
Procedure
Example
Configuring emergency call service location on port 2/1–2/3:
Switch:1>enable Switch:1#configure terminal Switch:1(config)#interface gigabitEthernet 2/1–2/3 Switch:1(config-if)#lldp location-identification ecs-elin 123456789
Variable Definitions
The following table defines parameters for the lldp location-identification ecs-elin command.
Variable |
Value |
---|---|
WORD<10–25> |
Specifies the emergency line information number for emergency call service. |