Use this procedure to load and
install the Tunnel Concentrator application on the Universal Compute Platform.
Log in to the Universal Compute Platform.
Go to Engines > Image
Management.
Locate the image file on your desktop.
Drag the image file onto the Universal Compute Platform desktop.
The install file uploads
automatically.
Go to Engines > Installation.
From the Extreme Tunnel Concentrator pane, select
Install.
In the popup window, select OK.
A new instance of Tunnel Concentrator displays on the Engines page along
with a link.
Within the Extreme Tunnel
Concentrator pane, select the link for your installation.
Configure the following settings:
Node
Affinity—Select the Universal Compute Platform node on
which this Tunnel Concentrator instance will run.
Port
1—Virtual function 01 on port 1 is used for licensing.
Note
The Tunnel Concentrator instance is locked to the VF
number.
Port (2, 3 and
4)—You can set these ports to any VF option.
Select Deploy.
After a delay of up to a
few minutes to process the updates, the Extreme Tunnel Concentrator
screen displays a set of four tabs.
Under the Network Service
Configuration tab, select the Assigned Virtual IP
Address drop-down and select an IP address for the Tunnel Concentrator service. This IP address also gets used to
generate a URL for GUI access.
Select Save.
After a few minutes, the screen displays an Instance web
interface link.
Select the Instance web
interface link to launch the Extreme Tunnel Concentrator
GUI.
