Display IPFIX Flows

About this task

Use the following procedure to display information about IPFIX flows. You can display information for all IPFIX flows, or you can specify a single IPFIX flow and display additional information about that flow.

Procedure

To enter User EXEC mode, log on to the switch.
Display information about all IPFIX flows:

show ip ipfix flows
Display information about an IPFIX flow learned on an ingress port:

Note

This step only applies to VSP 7400 Series.

show ip ipfix flows source-addr {A.B.C.D} dest-addr {A.B.C.D} source-port <1-65535> dest-port <1-65535> protocol {udp|tcp} in-port <rx-nni | {slot/port[/sub-port]}>

Example

Display all IPFIX flows:

Switch:1>show ip ipfix flows
==========================================================================================
                                  IPFIX Flows
==========================================================================================
Source           Destination      Source   Destination   Protocol   In
IP               IP               Port     Port                     Port
------------------------------------------------------------------------------------------
192.0.2.1        198.51.100.1     63       63            UDP        1/17
203.0.113.2      203.0.113.1      63       63            UDP        RX-NNI

Display information about a specific IPFIX flow:

Switch:1>#show ip ipfix flows source-addr 203.0.113.2 dest-addr 203.0.113.1 s 63 d 63 p udp in-port rx-nni
==========================================================================================
                                  IPFIX Flows
==========================================================================================
Source IP/       Src Port/   Protocol/   Start Time/                       Byte Count/
Destination IP   Dest Port   In Port     Observation Time                  Packet Count
------------------------------------------------------------------------------------------
203.0.113.2      63          UDP         Tue Apr 09 06:48:57 2019 UTC      352376
203.0.113.1      63          RX-NNI      Tue Apr 09 06:49:49 2019 UTC      5182

Variable Definitions

The following table defines parameters for the show ip ipfix flows command.


Variable	Value
dest-addr`{A.B.C.D}`	Specifies an IP address for the flow destination.
dest-port `<1-65535>`	Specifies a value for the destination port.
in-port <rx-nni \| `{slot/port[/sub-port]}`>	Specifies the port that learns the flow.
protocol`{udp\|tcp}`	Specifies the transport protocol.
source-addr `{A.B.C.D}`	Specifies an IP address for the flow source.
source-port `<1-65535>`	Specifies a value for the source port.