Display the tc-receive-alarm-threshold Configuration

About this task

You can configure a threshold rate for receiving TC/TCN packets. If the threshold is exceeded, you receive a warning message.

Use the following procedure to display the tc-receive-alarm-threshold configuration.

Procedure

  1. To enter User EXEC mode, log on to the switch.
  2. Display the tc-receive-alarm-threshold configuration:

    show spanning-tree tc-receive-alarm-threshold

Example

Switch:1(config)#show spanning-tree tc-receive-alarm-threshold

==========================================================================================
             Spanning Tree TC/TCN Rx Alarm Threshold Configuration
==========================================================================================
Interval                : 1 minutes
Count                   : 2
9039034-00 Rev AB