Display Global IS-IS Parameters
Use the following procedure to display the global IS-IS parameters.
Procedure
Example
Switch:1>show isis
================================================================================
ISIS General Info
================================================================================
AdminState : enabled
RouterType : Level 1
System ID : 0014.c7e1.33df
Max LSP Gen Interval : 900
Metric : wide
Overload-on-startup : 20
Overload : false
Csnp Interval : 10
PSNP Interval : 2
Rxmt LSP Interval : 5
spf-delay : 100
Router Name : Switch1
ip source-address : 41.41.41.100
ipv6 source-address : 41:0:0:0:0:0:0:100
ip tunnel source-address : 11.11.12.11
Tunnel vrf : spboip
ip tunnel mtu : 1950
Num of Interfaces : 2
Num of Area Addresses : 1
inband-mgmt-ip :
backbone : disabled
Dynamically Learned Area : 00.0000.0000
FAN Member : No
Hello Padding : enabled
Multi-Area OperState : disabled
Multi-Area Flags : home-always-up
Designated BN Hostname : BN4435
Designated BN Home System ID : 0010.7400.4435
Designated BN Remote System ID : 0020.7400.4435
Switch# show isis system-id
================================================================================
ISIS System-Id
================================================================================
SYSTEM-ID AREA AREA-NAME
--------------------------------------------------------------------------------
0014.c7e1.33df HOME
Switch# show isis net
================================================================================
ISIS Net Info
================================================================================
NET
--------------------------------------------------------------------------------
c0.2000.0000.0000.14c7.e133.df00