Display LACP Statistics for Specific Ports

Display individual LACP statistics for specific ports to manage network performance.

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. View statistics for specific ports:

    show interfaces GigabitEthernet statistics lacp [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

Example

View LACP statistics:

Switch:1>enable
Switch:1#show interfaces gigabitethernet statistics lacp

================================================================================
                                Port Stats Lacp
================================================================================
PORT TX     RX     TX        RX        TX            RX            RX      RX
NUM  LACPDU LACPDU MARKERPDU MARKERPDU MARKERRESPPDU MARKERRESPPDU UNKNOWN ILLEGAL
--------------------------------------------------------------------------------
1/39  0        0        0          0          0               0    0       0
1/40  0        0        0          0          0               0    0       0
2/1   0        0        0          0          0               0    0       0
2/2   0        0        0          0          0               0    0       0

Variable Definitions

Use the data in the following table to use the show interfaces GigabitEthernet statistics lacp command.

Variable

Value

{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}
Identifies the slot and port in one of the following formats:

  • a single slot and port (slot/port)

  • a range of slots and ports (slot/port-slot/port)

  • a series of slots and ports (slot/port,slot/port,slot/port)

  • all ports on the same slot (slot/all)

  • all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
9039034-00 Rev AB