

The VLAN tab displays the VLAN, Routing Level, Link Cost, Hello Packet Interval, and Adjacency Hold Time managed devices use to communicate securely with each another.

Note
If creating a mesh link between two access points in Standalone AP mode, you‘ll need to ensure a VLAN is available to provide the necessary MiNT link between the two Standalone APs.


| 
                                         VLAN  | 
                                    
                                         Define a VLAN ID from 1 - 4094 used by peer controllers for interoperation when supporting the MiNT protocol  | 
                                
| 
                                         Routing Level  | 
                                    
                                         Define or override a routing level of either 1 or 2.  | 
                                
| 
                                         Link Cost  | 
                                    
                                         Use the spinner control to define or override a link cost from 1 - 10,000. The default value is 10.  | 
                                
| 
                                         Hello Packet Interval  | 
                                    
                                         Set or override an interval in either seconds (1 - 120) or minutes (1 - 2) for the transmission of hello packets. The default interval is 4 seconds.  | 
                                
| 
                                         Adjacency Hold Time  | 
                                    
                                         Set or override a hold time interval in either seconds (2 - 600) or minutes (1 - 10) for the transmission of hello packets. The default interval is 13 seconds.  | 
                                
Click Reset to revert to the last saved configuration.