Using the NX-9600 Series Command Line Interface

Once the NX-9600 series hardware is installed, complete the following to access the Command Line Interface (CLI) on the controller:

1. On the configuration computer, configure a terminal emulation application as follows:

   Terminal Type	VT 100
   Port	COM port
   Terminal Settings	19200bps transfer rate 8 data bits no parity 1 stop bit no flow control no hardware compression

2. Apply power to the device.
3. When the prompt is displayed in the terminal window, login using the username admin and password admin123.
4. For increased security, you are prompted to enter a new password. Enter the new password then enter it again to confirm it.