You can configure ESRP to track hardware status. If a power supply
fails, if the switch is overheating, or if a non-fully loaded power supply is detected, the
priority for the ESRP domain will change to the failover settings.
Note
ExtremeXOS software determines the maximum available power required
for the switch by calculating the number of power supplies and the power required by the
installed modules. Enabling environmental tracking on the switch without enough power
budget causes tracking to fail. In this case, the tracking failure occurs by
design.
To configure the failover priority for an ESRP domain:
-
Set the failover priority using the following
command:
configure
esrp esrpDomain add track-environment failover priority
-
Assign the priority flag precedence over the active ports
count using the following command:
configure
esrp esrpDomain election-policy [ports > track > priority | ports > track > priority > mac | priority > mac | priority > ports > track > mac | priority > track > ports > mac | sticky > ports > track > priority | sticky > ports > track > priority > mac | sticky > ports > weight > track > priority > mac | sticky > priority > mac | sticky > priority > ports > track > mac | sticky > priority > track > ports > mac | sticky > track > ports > priority | sticky > track > ports > priority > mac | track > ports > priority | track > ports > priority > mac]
Because the priority of both ESRP domains are set
to the same value, ESRP will use the active ports count to determine the master ESRP
domain.
