Create an Ingress Group

Ingress-group classifies the packets received on 9920 at ingress.

Before you begin

Note the following naming conventions for name identifiers:

The name cannot exceed 64 characters.
The name must start with an alphabet character or an underscore.
The name must contain alphanumeric characters and special characters (underscores, hyphens, or periods).
The following reserved keywords cannot be used as name identifiers: all, ingress-group, egress, egress-group, match, list, access-list, route-map, and listener-policy.

About this task

You can associate an ingress-group with a route-map using the set command to apply various actions or policies to the traffic at the specified tap interface.

Note

A port can either be an individual port or a member port-channel.

A port associated with an ingress-group configuration cannot be configured as a member port-channel until its active configurations are cleared.

Procedure

Enter the Config mode.
```
device(config)# 
```

Create an ingress group.

device# ingress-group group-name
device# configure terminal
device(config)# ingress-group ingress-group noc_traffic
device(config-ingress-group)# set route-map rmap1

Verify that the ingress group is created.

device# show running-config ingress-group
ingress-group noc_traffic
  set route-map rmap1