VOSS 8.4.2 incorporates all fixes from prior releases, up to and including VOSS 8.3.1 and VOSS 8.4.1.1:
Issue number |
Description |
---|---|
VOSS-13938 |
You can configure LLDP-MED on an FA-enabled port, and show lldp commands show the configuration as applied but the information is not advertized and it does not appear in show running-config output nor in config.cfg if you save the configuration |
VOSS-19652 |
XA1480 rebooting by itself with core. |
VOSS-20143 |
EDM: While placing the cursor on the port, the port label show up incorrect. |
VOSS-20214 |
LLDP med + Mitel IP phone not working. |
VOSS-20449 |
VSP 7400 Series - IPFIX flows 'Timestamp/obseravation time' is not in sync with system time. |
VOSS-20462 |
EDM: LldpAuthEnabled, DynamicMHSAEnabled and FlexUniStatus are not displayed right. |
VOSS-20521 |
VSP 4900 Series Ports 2+8n (2, 10, 18, 26....) frequently go down for no reason. |
VOSS-20642 |
After upgrading, port names are not shown in EDM when configuring from CLI. The same issue happens when configuring with EDM. |
VOSS-20648 |
XA1400 Series – could hit an exception when ipsec/FE tunnel is taken down. |
VOSS-20696 |
DvR Leaf cannot delete mgmt clip; error message saying VLAN must be deleted first. |
VOSS-20711 |
Endianness issue on VSP 4900 Series, VSP 7400 Series, and XA1400 Series with NTP server when specific DNS servers are used. |
VOSS-20723 |
IST, SMLT, and VRRP went down briefly after enabling access policy configuration. |
VOSS-20793 |
Set IS-IS sys-name to same system name pushed by Extreme Management Center. |
VOSS-20801 |
Device crashed with core dump Process dhclient-fan. |
VOSS-20802 |
VSP4900-48P - LLDP-MED not assigning ip phone to voice VLAN. |
VOSS-20831 |
Decode “DBSYNC WARNING DB Sync Duplicate TLV” log. |
VOSS-21019 |
show khi cpp port-statistics showing DvR TLV packets as unspecified. DvR TLV packets are counted as MinM_Ether2_DBSync. |
VOSS-21186 |
Sys msg-control feature "force-msg" filters all other log messages. sys msg-control control-interval 1 max-msg-num 2 sys force-msg "Down" sys msg-control After enabling sys msg-control all logs that had the "Down" pattern in them are cut and if the other logs that don't have the "Down" pattern are shown more than 2 times in 1 minute will be suppressed and is replaced with : 1 2021-07-27T21:10:11.980Z VSP8284_LEFT CP1 - 0x000005ce - 00000000 GlobalRouter SW INFO msgControl: messages starting with 'Ospf' suppressed. For example, if we have the following configuration: sys msg-control control-interval 1 max-msg-num 2 sys msg-control All logs that appear more than 2 times in 1 minute will be suppressed and replaced with a similar log with the preceding example. |
VOSS-21228 |
IE 11 connects and displays switch/ports but none of menu items function. |
VOSS-21280 |
ACEs for the lowest index VLAN defined in ACL configuration stop getting hit when ACL is toggled. Bouncing ACE recovers the issue. |
VOSS-21281 |
VSP 7400 Series 10G AoC DAC Cable: Exhibiting random operational link down. |
VOSS-21390 |
DvR Leaf clear isis lsdb causes the default route for CLIP in-band mgmt to disappear. |
VOSS-21465 |
5520 Series: One switch in vIST cored when Extreme Management Center accessed the switch after some time. |
VOSS-21622 |
EDM displays incorrect PoE port values for Voltage(volts, Current(amp), and Power(watts). |
VOSS-21640 |
When you use the no auto-sense enable convert-to-config command to disable Auto-sense on a port, which is in the VOICE state and EAP is globally enabled, the ORIGIN for the voice S-UNI does not change from A (Auto-sense) to C (config). |
VOSS-21649 |
On rare occasions when you configure Multi-area SPB, C-MAC address flapping and traffic issues might be seen on interior nodes. |
VOSS-21657 |
Booting VSP 8404C with 3 or 4 8408QQ ESMs results in slot 3 and/or slot 4 becoming non-operational . |
VOSS-21662 |
Switch crashes when I2C operation hangs. |
VOSS-21664 |
In some situations, when BFD is used in conjunction with Fabric Extend, the switch might hit a software anomaly and reset. |
VOSS-21672 |
DvR into OSPF redistribution on a DvR controller triggering continuous logs rtmAddRoute: cannot add route on other DVR controllers in the network. |
VOSS-21688 |
VSP 7400 Series does not use the original static IPv6 routes after reconvergence of the network. |
VOSS-21711 |
High CPU ~60 % due to SnmpTmr task. |
VOSS-21750 |
Editing license file causes switch to reboot with core file. |
VOSS-21801 |
VOSS 8.4: Using default VLAN name of not configured VLAN accepted in CLI and leads to configuration loss on reboot. |
VOSS-21819 |
Core Dump : GlobalRouter SW INFO Stopping process hckServer, pid:535. |
VOSS-21860 |
High CPU due to pthread tDigitalCertSce. |
VOSS-21885 |
Unable to add valid syslog host addresses with last octet as 0. |
VOSS-21907 |
5520-24X and 5520-24T: Fan 1 LED state is always "AmberSteady". |
VOSS-21911 |
VSP 4450 Series logging RCIP6 INFO 85% of route limit reached for combined ipv4/v6 routes. |
VOSS-21932 |
On disabling and enabling Auto-sense Error: Auto-Sense not allowed on LLDP DOT3 enabled ports. |
VOSS-21951 |
Username and password changed in EDM revert to default after switch reboot. |
VOSS-21974 |
Error 682: Failed to delete sw-uni on configuring "auto-sense data i-sid x" . |
VOSS-21975 |
VSP 8404: After an upgrade from 8.1.9 to 8.2.7, port names longer than 42 characters are removed from the configuration. |
VOSS-21981 |
RADIUS attribute Egress-VLAN-ID together with multiple FA-VLAN-ISID does not create any tagged VLAN. |
VOSS-21990 |
8.3 and later does not allow Diffie-Hellman Group1 SSH connection. |
VOSS-22024 |
Multi-Area: When the Non-Designated BN becomes Designated, IP route table not redistributed. |
VOSS-22045 |
Onboarding VLAN is missing from show i-sid table. |
VOSS-22061 |
1G fiber port on VIM5-4XE module reverting to “no auto-negotiate” after reboot. |
VOSS-22070 |
5520-24T: FAN status does not match at CLI/LED and actual placement from the backside. |
VOSS-22102 |
5520 Series (8.3.1.0) Switch loses configured flex-uni assignment after EAP reauthentication expires. |
VOSS-22128 |
VSP with CDP enabled cannot display the ESXi servers that they are connected to in the show lldp neighbor command outuput. |
VOSS-22129 |
VSP 7400 Series: cannot login to the switch using SSH. |
VOSS-22138 |
fbuf > 60% logs every few minutes. |
VOSS-22164 |
8.1.7: Port Error reading DDI data: 0, errno: 110, port: <PORT_NUM> in error state after hot insert of a pluggable module. Attempting to restore it. |
VOSS-22165 |
VSP 7432CQ port mapping incorrectly displayed in log. |
VOSS-22181 |
Transitioning from FA state to UNI onboarding state during CANA process sometimes requires data I-SIDto be configured. However, this either disables EAP, thus breaking CANA process, or does not switch I-SID, which results in undefined behavior. |
VOSS-22232 |
DHCP Discover packet going into NLS stack and gets dropped with Snooping enabled. |
VOSS-22251 |
show dvr database command crashes switch. Also occurs in show fulltech command. |
VOSS-22269 |
VOSS: One DHCP discover packet leak via Auto-sense voice VLAN when NEAP phone rejected by RADIUS. |
VOSS-22283 |
VOSS 8.3 and later: Using FQDN when web-server secure mode fails with SSL_ERROR_NO_CYPHER_OVERLAP. |
VOSS-22304 |
Multi-Area IP unicast route reachability issue. |
VOSS-22307 |
Custom banner is not displayed when accessing switch using SSH. Same custom banner is displayed when accessing switch using Telnet or EDM. |
VOSS-22367 |
Unable to set FE-IP destination IP address fourth octet to zero. |
VOSS-22368 |
Multi-Area IP unicast route reachability issue. |
VOSS-22584 |
Switch crashes when a zero size packet is sent from BFD. |