The following defects are open in this release of the software.
| Parent Defect ID: | NPB-5182 | Issue ID: | NPB-5182 |
|---|---|---|---|
| Severity: | S2 - Major | ||
| Product: | 9920 | Reported in Release: | NPB 21.1.1.0 |
| Symptom: | Entity MIB item entPhysicalVendorType does not return any Vendor type OIDs instead it just return {0 0} when SNMP walk is performed | ||
| Condition: | This happens always during SNMP walk of entPhysicalVendorType in the entity MIB. | ||
| Workaround: | No workaround | ||
| Recovery: | No recovery available | ||
| Parent Defect ID: | NPB-5188 | Issue ID: | NPB-5188 |
|---|---|---|---|
| Severity: | S3 - Moderate | ||
| Product: | 9920 | Reported in Release: | NPB 21.1.1.0 |
| Symptom: | "Link Fault Status" field in "Show interface ethernet" might show incorrect fault status. | ||
| Condition: | "no shutdown" on the ethernet interface. | ||
| Recovery: | No functional impact. | ||
| Parent Defect ID: | NPB-5724 | Issue ID: | NPB-5724 |
|---|---|---|---|
| Severity: | S3 - Moderate | ||
| Product: | 9920 | Reported in Release: | NPB 21.1.2.0 |
| Symptom: | LACP port-channel remains down after replaying the configuration with lacp rate as 'fast' in the member interfaces. | ||
| Condition: |
The issue is seen when the lacp configurations are replayed with the node in default-configs. Only when "lacp rate fast" is configured on member ports. |
||
| Workaround: | If we reboot the system with config it will work properly or change the "lacp rate normal" and after the port-channel comes up again change it to "lacp rate fast" on member ports. | ||
| Recovery: | Disable & enable lacp in the global config mode. ('no protocol lacp' & 'protocol lacp') | ||