Open Defects
The following defects are open in this
release of the software.
| Parent Defect ID: |
NPB-5182 |
Issue ID: |
NPB-5182 |
| Severity: |
S2 - Major |
| Product: |
NPB |
Reported in Release: |
NPB 21.1.1.0 |
| Symptom: |
Entity MIB item entPhysicalVendorType
does not return any Vendor type OIDs instead it just return {0 0} when
SNMP walk is performed |
| Condition: |
The symptom always happens during SNMP
walk of entPhysicalVendorType in the entity MIB. |
| Workaround: |
No workaround |
| Recovery: |
No recovery available |
| Parent Defect ID: |
NPB-5188 |
Issue ID: |
NPB-5188 |
| Severity: |
S3 - Moderate |
| Product: |
NPB |
Reported in Release: |
NPB 21.1.1.0 |
| Symptom: |
"Link Fault Status" field in "Show
interface Ethernet" might show incorrect fault status. |
| Condition: |
"no shutdown" on the Ethernet
interface. |
| Recovery: |
No functional impact. |
| Parent Defect ID: |
NPB-5724 |
Issue ID: |
NPB-5724 |
| Severity: |
S3 - Moderate |
| Product: |
NPB |
Reported in Release: |
NPB 21.1.2.0 |
| Symptom: |
LACP port-channel remains down after
replaying the configuration with lacp rate as 'fast' in the member
interfaces. |
| Condition: |
The issue is seen when the lacp
configurations are replayed with the node in default-configs only when
"lacp rate fast" is configured on member ports. |
| Workaround: |
If you reboot the system with config, it
will work properly or change the "lacp rate normal" and after the
port-channel comes up again change it to "lacp rate fast" on member
ports. |
| Recovery: |
Disable and enable lacp in the global
config mode. ('no protocol lacp' and 'protocol lacp') |
