Configuring header protocols for load-balancing

Select the protocol header type using one of the following commands. By default, all the header parameters are enabled as shown here. If you disable a header, you can then re-enable its parameters one-by-one.

• Ethernet headers:
  • load-balance hash ethernet da-mac
  • load-balance hash ethernet etype
  • load-balance hash ethernet sa-mac
  • load-balance hash ethernet vlan
  • load-balance hash ethernet smac-dmac
• IPv4 and L4 headers
  • load-balance hash ip dst-ip
  • load-balance hash ip dst-l4-port
  • load-balance hash ip protocol
  • load-balance hash ip src-ip
  • load-balance hash ip src-l4-port
  • load-balance hash ip sip-dip
• IPv6 and L4 headers
  • load-balance hash ipv6 ipv6-dst-ip
  • load-balance hash ipv6 ipv6-dst-l4-port
  • load-balance hash ipv6 ipv6-next-hdr
  • load-balance hash ipv6 ipv6-src-ip
  • load-balance hash ipv6 ipv6-src-l4-port
  • load-balance hash ipv6 sipv6-dipv6
• MPLS:
  • load-balance hash mpls label1
  • load-balance hash mpls label2
  • load-balance hash mpls label3
  • load-balance hash mpls all-labels
• L4 headers:
  • load-balance hash l4 src-dst-port