Connect a Power Supply

Before you begin

Obtain a Powertron 12V DC power supply. The power supply is ordered separately. See the table below.

Caution

Only use Extreme approved power supplies for your access point. Unapproved third-party components can damage your AP.

Table 1. Power Accessory
Part number	Description
37219	PWR 12VDC, 3A, 2.5 mm X 5.5 mm connector

About this task

You can power the AP through the ETH0 RJ45 Ethernet port. But if you prefer an external power supply, then you can use the 12V DC power supply. See the Power Profile for power consumption specifications.

The AP5020 12V Port is located next to the ETH1 port.

Table 2. AP5020 12V Port
Item	Description	Use
1	12V DC	12-volts of direct current.

Procedure

Plug the power supply into the 12-volt power connector.

Results

The LED on the top of the AP lights up. It should be white. If the LED is amber, then your AP has a technical issue.