Release Notes for ExtremeSecurity V7.7.2.8 Patch 3

Extreme Networks is pleased to introduce the ExtremeSecurity V7.7.2.8 Patch 3.

Note

We recommend that you review this document prior to installing or upgrading this product.

About this Patch

Fix packs are cumulative software updates to fix known software issues in your ExtremeSecurity deployment. There are five APARs associated with ExtremeSecurity V7.7.2.8 Patch 3, which address a number of specific issues in ExtremeSecurity V7.7.2.8. ExtremeSecurity fix packs are installed by using an SFS file. The fix pack can update all appliances attached to the ExtremeSecurity Console. If your deployment is installed with any of the following ExtremeSecurity versions, you can install fix pack 7.2.8-QRADAR-QRFULL-20170105231716 to upgrade to ExtremeSecurity 7.7.2.8 Patch 3:

Note

The 7.2.8-QRADAR-QRFULL-20170105231716 fix pack can upgrade ExtremeSecurity 7.7.2.4 (7.2.4.983526) and later to the latest software version. However, this document does not cover all of the installation messages and requirements, such as changes to memory requirements or browser requirements for ExtremeSecurity. To review any additional requirements, see the ExtremeSecurity Upgrade Guide. If you are on a version of ExtremeSecurity earlier than 7.7.2.4, you must upgrade to 7.7.2.4 before proceeding to 7.7.2.8.

Resolved Issues

Note

Some APAR links in the table below might take 24 hours to display properly after a software release.