Configure Connectivity Fault Management Maintenance Endpoint

Use this procedure to configure the Connectivity Fault Management (CFM) Maintenance Endpoint (MEP). A MEP represents a managed CFM entity, associated with a specific Domain Service Access Point (DoSAP) of a service instance, which can generate and receive CFM Protocol Data Units (PDU) and track any responses. A MEP is created by MEP ID under the context of an MA.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Create the CFM MEP:

cfm maintenance-endpoint WORD<0–22> WORD<0–22> <1–8191> enable [state <enable>]
Enable an existing CFM MEP:

cfm maintenance-endpoint WORD<0–22> WORD<0–22> <1–8191> enable
Disable an existing CFM MEP:

no cfm maintenance-endpoint WORD<0–22> WORD<0–22> <1–8191> enable
Display the CFM MEP configuration:

show cfm maintenance-endpoint
Delete an existing CFM MEP:

no cfm maintenance-endpoint WORD<0–22> WORD<0–22> <1–8191>

Example

Switch:1> enable

Switch:1# configure terminal

Switch:1(config)# cfm maintenance-endpoint md1 ma1 1 state enable

Switch:1(config)# show cfm maintenance-endpoint

================================================================================
                         Maintenance Endpoint Config
================================================================================
DOMAIN                 ASSOCIATION            MEP  ADMIN
NAME                   NAME                   ID
--------------------------------------------------------------------------------
md1                    ma1                    1    enable

 Total number of MEP entries: 1.

================================================================================
                         Maintenance Endpoint Service
================================================================================
DOMAIN_NAME            ASSN_NAME              MEP_ID TYPE    SERVICE_DESCRIPTION
--------------------------------------------------------------------------------
md1                    ma1                    1      nodal   Vlan 1, Level 4

 Total number of MEP entries: 1.

Variable Definitions

The following table defines parameters for the cfm maintenance-endpoint command.


Variable	Value
`WORD<0–22>`	The first parameter, specifies the MD name.
`WORD<0–22>`	The second parameter, specifies the MA short name.
`<1–8191>`	Specifies the MEP ID.
enable	Enables an existing MEP. Use this parameter with the no option to disable an existing MEP.
state {enable \| disable}	Enables or disables the MEP when creating the MEP. The default is disabled.