Configure Remote IS-IS System ID

About this task

Perform this procedure to configure the remote Intermediate System-to-Intermediate System (IS-IS) system ID on the switch.

Procedure

  1. Enter IS-IS Router Remote Configuration mode:

    enable

    configure terminal

    router isis remote

  2. Configure the remote IS-IS system ID:

    system-id xxxx.xxxx.xxxx

Example

Configuring the remote IS-IS system ID:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#router isis remote
Switch:1(config-isis-remote)#system-id 0017.c6ed.44df

What to do next

To verify the configuration, see Display IS-IS Remote Area Configuration and Display IS-IS Area Configuration.

Variable Definitions

The following table defines parameters for the system-id command.

Variable Value
xxxx.xxxx.xxxx

Specifies the remote IS-IS system ID for the switch.