Configure an IP Address for a Segmented Management Instance

Use this task to configure and view IPv4 address information for a Segmented Management Instance.

Before you begin

  • Ensure the IP address you plan to assign is not in use by an existing VLAN or CLIP IP subnet configured on the switch.

  • If the DHCP client is configured for a Segmented Management Instance, you must manually disable the client. Configuring an IP address does not automatically disable the DHCP client.

Procedure

  1. In the navigation pane, expand Configuration > Edit.
  2. Select Mgmt Instance.
  3. Select Mgmt.
  4. Select the IpAddress tab.
  5. Select Insert.
  6. Select the Segmented Management Instance interface type.
  7. Type the address information.
  8. Select Insert.

IpAddress Field Descriptions

Use the data in the following table to use the IpAddress tab.

Name

Description

InstanceId

Specifies the interface instance.

Address

Specifies IPv4 address for the interface instance.

Ensure that the management CLIP IP address does not fall into the range of a configured VLAN IP address range as this is not allowed.

Mask

Specifies the subnet mask of the IP address.

AddrOrigin

Shows the IP address origin.

IntfName

Shows the interface name.