Mounting the AP to the Bracket

About this task

After you attach the bracket to a wall or junction/gang box and connect the LAN/power, attach the AP to the bracket.

Procedure

  1. Stuff any extra GE1 cable into the wall/box.
  2. Keep the bracket at an angle and insert the two tabs at the top of the bracket into the AP.
  3. Rotate the AP on the tabs and wait for it to clip to the other side of the bracket. The other side of the bracket is on the bottom of the AP where the cable enters.
  4. Attach and tighten the Security Torx screw to the bottom of the AP so that the AP is attached to the bracket. Torque the screw to 7 in-lbs.
    Click to expand in new window
    Note

    Note

    If you are using the optional 12V DC-IN adapter instead pf PoE on GE1 port, then cfully insert the friction fit connector into the AP. Plug the AP into an AC receptable.
9035058