Power over Ethernet (PoE) is the power source for an AP-8163 Access Point. For optimal performance, an AP-8163 can be powered by the following injectors and RFS controllers that support 802.AT PoE.
The AP-PSBIAS-7161 is a 1-Port 802.3at PoE Gigabit Ethernet injector. The injector is IP66 rated for outdoor deployments when used with the weatherproof kit supplied.
Note
Product installation and mounting instructions are provided with the outdoor power injector. Refer to the AP-PSBIAS-7161 Install Guide.If located within 100 meters of the controller and a PoE port is available, the AP-8163 Access Point can also be connected directly to a controller or service platform running WiNG 5.6 or higher.
A standard CAT5E cable can be used to provide the connection to the AP-8163. The GE1/POE port on the AP-8163 is where the standard CAT5E cable will connect to the Access Point and use of the weatherproof RJ45 plug kit that comes with the unit will maintain a weatherproof seal for outdoor installation at the ethernet port.
Caution
When using controllers, the total power limits for the AP-8163 must be considered. The two radio configuration draws less power than a three radio configuration. If sufficient power is not available, the AP-8163 software will disable the third radio and throttle back performance on all radio and Ethernet interfaces.