Install the Access Point on a Wall or a Solid Surface Using the AH-ACC-BKT-AX-TB Bracket

Install the access point on a wall or a solid surface using the AH-ACC-BKT-AX-TB bracket and the appropriate mounting hardware.

Before you begin

Hardware requirements for installation:
  • One AP4000 access point
  • One AH-ACC-BKT-AX-TB bracket
  • Two screws
  • Two anchors, if needed

About this task

The access point can be installed on a wall or a solid surface using the AH-ACC-BKT-AX-TB bracket paired with two screws and screw-in anchors, if needed.

To install the access point:

Procedure

  1. Place the AH-ACC-BKT-AX-TB bracket on a wall or a solid surface, and mark and drill two mounting holes.
    Click to expand in new window
    AH-ACC-BKT-AX-TB bracket with wall mounting holes
    AH-ACC-BKT-AX-TB circular bracket
    Callout Description
    1 Metal angled cuts
    2 Wall mount holes
    3 White tab
  2. Attach the bracket to the wall using two screws.
    Use screw in anchors, if needed.
  3. Attach the Ethernet port cap to the access point Ethernet port.
  4. Align the red dot on the back of the access point against the red dot on the bracket.
    Note

    Note

    The bracket has a center circular tip that fits into the circular dip on the back of the access point.
  5. Press and rotate the access point 1/8th turn clockwise until it clicks into place on the bracket.
  6. Attach the Cat6 RJ45 cable to the Eth0 or Eth1 port.
  7. Place the cable cover over the Ethernet cable.
9037237-01 Rev AB