View AP Events — Single Access Point

Review AP events from the AP Events tab.

Go to Monitor > Devices > Access Points.
Select an access point.
Select the Events tab.

The following history reports are available:

Reboot History — User requested restarts and AP initiated restarts
Upgrade History — A count for successful upgrades and failed upgrades
Radar Detection — The number of times radar is detected by the AP.
When using a DFS Channel, the AP must listen for radar. When radar is detected, the AP stops transmission on that channel, marks the channel as unusable (for 30 minutes), and immediately switches to new channel based on the configured channel plan.

Select to set the Duration value for the time period reported. Valid duration values are:
- Last 3 hours
- Last 3 days
- Last 14 days
Select to refresh the data on demand.
Hover the mouse over a widget to display tool tip information.

Enable Debug Logging — This option sets the Event log level to Informational. The log is refreshed every 20 seconds. It can take up to 2 minutes for new log messages to display. This setting is disabled after you navigate away from the Events page, automatically reinstating the previous log level.