Recover from an Upgrade Failure

You can recover from an upgrade failure by rerunning the upgrade or by performing a fresh installation and then restoring the system with the backup taken at the beginning of the upgrade process.

1. To rerun the upgrade, follow the steps for the type of upgrade you were attempting.
   • Upgrade EFA from a Single-node to a Multi-node Deployment
   • Upgrade EFA on TPVM in a Single-node Deployment
   • Upgrade EFA in a Single-node Deployment
   • Upgrade EFA in a Multi-node Deployment
   • Upgrade EFA on TPVM in a Multi-node Deployment
2. To perform a fresh installation and restore the system backup, take the following steps.
   1. Uninstall EFA to remove any components that might have been installed before the upgrade failed.
      • Uninstall EFA on TPVM in a Multi-Node Deployment
      • Uninstall EFA in a Multi-node Deployment
      • Uninstall EFA on TPVM in a Single-Node Deployment
      • Uninstall EFA in a Single-Node Deployment
   2. Follow the steps for the type of installation you need.
      • Install EFA on TPVM in a Multi-Node Deployment
      • Install EFA in a Multi-Node Deployment
      • Install EFA on TPVM in a Single-Node Deployment
      • Install EFA in a Single-Node Deployment
   3. Restore the backup.
      

      device# efa system restore --backup-tar <filename>.tar.gz

      For more information about backup tar files, see the "Database Backup and Restoration" section of the Extreme Fabric Automation Administration Guide, 2.4.0 .