The following issues were resolved in ExtremeXOS 30.7.2-Patch1-33. ExtremeXOS 30.7.2-Patch1-33 includes all fixes up to and including ExtremeXOS 11.6.5.3, and earlier, ExtremeXOS 12.0.5, ExtremeXOS 12.1.7, ExtremeXOS 12.2.2-patch1-12, ExtremeXOS 12.3.6, ExtremeXOS 12.4.5, ExtremeXOS 12.5.5, ExtremeXOS 12.6.3, ExtremeXOS 12.6.5, ExtremeXOS 12.7.1, ExtremeXOS 15.1.5, ExtremeXOS 15.2.4, ExtremeXOS 15.3.3, ExtremeXOS 15.4.1, ExtremeXOS 15.5.1, ExtremeXOS 15.5.2, ExtremeXOS 15.6.1, ExtremeXOS 15.6.2, ExtremeXOS 15.7.1, ExtremeXOS 16.1, ExtremeXOS 16.1.2, ExtremeXOS 16.1.3, ExtremeXOS 21.1, ExtremeXOS 22.1, ExtremeXOS 22.2, ExtremeXOS 22.3, ExtremeXOS 22.4, ExtremeXOS 22.5, ExtremeXOS 22.6, ExtremeXOS 30.1, ExtremeXOS 30.2, ExtremeXOS 30.3, ExtremeXOS 30.4, ExtremeXOS 30.5, ExtremeXOS 30.6, and ExtremeXOS 30.7. For information about those fixes, see the release notes for the specific release.
| Defect | Description |
|---|---|
| General | |
| EXOS-28961 | An authentication failed log appears for the Network login 802.1x user, even when there is no EAPOL response from the client. |
| EXOS-29431 | On upgrading from ExtremeXOS 30.2 to an ExtremeXOS 30.3 or later release, the IP security module removes configuration after violation-none. |
| EXOS-29486 | If nodealias and netlogin are enabled on the same port, then the nodealias entry will not be created for a client unless the client sends a packet destined for the switch CPU. |
| EXOS-29508 | L3VPN routes are not installed if VPN VRF is configured after the BGP neighbor. |
| EXOS-29543 | Introduce a CLI to the unconfigure dhcp-binding storage filename command. |
| EXOS-29764 | Netlogin authentication fails when VLAN is statically created but the dynamic VLAN creation request is received from a RADIUS accept packet. |
| EXOS-29821 | RTMGR process crashed with signal 11 when an IPv6 tunnel packet is received despite the switch not having tunneling configuration. |
| Extended Edge Switching | |
| EXOS-29450 | The VPEX process ends unexpectedly right after the Controlling Bridge (CB) boot up if the loaded configuration is different from the saved configuration. |
| EXOS-29826 | In a VPEX environment, the HAL process ends unexpectedly on a reboot of the Controlling Cridge (CB). |
| EXOS-29827 | In a VPEX MLAG Multiple Ring topology, when reboot all is run from one of the CBs, rings are stuck in the "Topology: Ring (Severed) - Formation Disabled" state. |
| ExtremeCloud IQ | |
| EXOS-29833 | After disabling IQ Agent, the switch is continuously trying to establish a connection with ExtremeCloud IQ when it is not reachable. |
| VXLAN | |
| EXOS-29531 | VXLAN error messages are observed and a port is not added to hardware table. |