The following issues were resolved in ExtremeXOS 31.5. ExtremeXOS 31.5 includes all fixes up to and including the following versions: 11.6.5.3 and earlier, 12.0.5, 12.1.7, 12.2.2-patch1-12, 12.3.6, 12.4.5, 12.5.5, 12.6.3, 12.6.5, 12.7.1, 15.1.5, 15.2.4, 15.3.3, 15.4.1, 15.5.1, 15.5.2, 15.6.1, 15.6.2, 15.7.1, 16.1, 16.1.2, 16.1.3, 21.1, 22.1, 22.2, 22.3, 22.4, 22.5, 22.6, 30.1, 30.2, 30.3, 30.4, 30.5, 30.6, 30.7, 31.1, 31.2, 31.3, and 31.4. For information about those fixes, see the release notes for the specific release.
Defect Number | Description |
---|---|
General | |
EXOS-29044 | There is a need to display the debug packet capture status under show tech. |
EXOS-29722 | The show configuration difference command shows the difference in the CFGMGR configuration if the banner has '<' or '>' symbols. |
EXOS-29734 | Unable to remove the dhcp-bindings storage filename from configuration. |
EXOS-29861 | The Netlogin mac password gets lost after a switch reboot. |
EXOS-29886 | Process aaa pid 1050 ends with signal 6 during a Defensics TACACS-Client test suite run. |
EXOS-29891 | Proess netTools ends with signal 6 while running the Defensics DNS-Client test suite. |
EXOS-30101 | Fix for vulnerability mentioned in CVE-2021-33909. |
EXOS-35735 | SNMP Set Failure for unregister trap in x620. |
EXOS-35763 | Auto Generation for NETSNMP - configuration files, added deprecated MIB objects to support XIQ-SE. |
EXOS-36098 | Enforcing an L7 Policy with Role ACL Mode enabled results in errors. |
EXOS-36170 | i386: Snmpwalk for dot1dTp returns wrong value. |
EXOS-36213 | SNMP crash - daemon.err snmpd[1822]: Error opening specified endpoint "udp6:161", |
CFD-11258 | Designate ports information show in a different order [flipped]. |
CFD-11367 | Memory leak on snmpd process. |
ExtremeSwitching X460-G2 Series Switches | |
EXOS-29852 | The switch fails to ask for the correct password again when a password mismatch occurs while creating an account in enhanced security mode. |
ExtremeSwitching X690 Series Switches | |
EXOS-29439 | RTMGR process crashes with signal 11 when an IPv6 tunnel packet is received, despite the switch not having a tunneling configuration. |
EXOS-29723 | A HAL.Card.Error is observed when executing the show ports information detail command in ExtremeXOS 31.1 and later releases. |
ExtremeSwitching 5520 Series Switches | |
EXOS-30076 | Unable to ping directly connected hosts on a specific VLAN due to a missing local route in the hardware. |
Extended Edge Switching | |
EXOS-29698 | VPEX process ends unexpectedly right after Controlling Bridge (CB) boot up if the loaded configuration is different from the previously saved configuration. |
MACsec | |
EXOS-29524 | Occasional flaps on MACsec-enabled ports occur when connected to slower-running hardware (for example, the ExtremeSwitching X620 series switch). |
MLAG | |
EXOS-29874 | VPLS/VPWS Improper ARP handling. |
OSPFv2 | |
EXOS-29482 | Routes redistribution from OSPF to RIP creates issues when removing NLRI from Routing Policy. |
SummitStack | |
EXOS-29812 | The SSH connection refuses to connect after stack failover. |
VLAN | |
EXOS-29034 | Users are not able to configure IPv6 addresses with VLAN tag instead of VLAN name. |
VXLAN | |
EXOS-29901 | The tunnel with remote endpoint and local endpoint is operationally down for unicast. |