The following issues were resolved in ExtremeXOS 31.7.2-Patch1-21. Version 31.7.2-Patch1-21 includes all fixes up to and including the following versions: 11.6.5.3 and earlier, 12.0.5, 12.1.7, 12.2.2-patch1-12, 12.3.6, 12.4.5, 12.5.5, 12.6.3, 12.6.5, 12.7.1, 15.1.5, 15.2.4, 15.3.3, 15.4.1, 15.5.1, 15.5.2, 15.6.1, 15.6.2, 15.7.1, 16.1, 16.1.2, 16.1.3, 21.1, 22.1, 22.2, 22.3, 22.4, 22.5, 22.6, 30.1, 30.2, 30.3, 30.4, 30.5, 30.6, 30.7, 31.1, 31.2, 31.3, 31.4, 31.5, 31.6, and 31.7. For information about those fixes, see the release notes for the specific version.
Version 31.7 also includes fixes for issues found in Switch Engine 31.6. Version 31.6 was the first version of Switch Engine.
| Defect Number | Description |
|---|---|
| General | |
| CFD-9530 | CLI paging does not work for the alias command. |
| CFD-9545 | PIM router stops sending traffic over an ISC port after receiving leave. |
| CFD-9563 | SNMPmaster signal 11 crash observed after switch restart. |
| EXOS-34046 | MVRP not correctly applying VLANs to ports with MLAG. |
| EXOS-34282 | The last port of a VLAN cannot be deleted using SNMP. |
| ExtremeSwitching X440-G2 Series Switches | |
| EXOS-34149 | CPU consumption is high when sending multicast packets in an ExtremeSwitching X440-G2 stack. |
| ExtremeSwitching X870 Series Switches | |
| EXOS-33685 | The ExtremeSwitching X870 should not allow 3 times port partition. |
| SummitStack | |
| EXOS-34004 | The SNMP trap source IP address configured using SNMP set requests is not saved to the stack backup and is lost if the stack primary is restarted. |
| EXOS-34082 | Error observed when enabling MACsec on the primary node of an ExtremeSwitching X465-48p stack. |
| EXOS-34292 | Default configuration for non-primary slots are shown under normal configuration. |
| Extended Edge Switching | |
| EXOS-34263 | MLAG can be enabled on a cascade port in a VPEX+Stacking environment. |