The following issues were resolved in ExtremeXOS 32.5. Version 32.5 includes all fixes up to and including the following versions: 11.6.5.3 and earlier, 12.0.5, 12.1.7, 12.2.2-patch1-12, 12.3.6, 12.4.5, 12.5.5, 12.6.3, 12.6.5, 12.7.1, 15.1.5, 15.2.4, 15.3.3, 15.4.1, 15.5.1, 15.5.2, 15.6.1, 15.6.2, 15.7.1, 16.1, 16.1.2, 16.1.3, 21.1, 22.1, 22.2, 22.3, 22.4, 22.5, 22.6, 30.1, 30.2, 30.3, 30.4, 30.5, 30.6, 30.7, 31.1, 31.2, 31.3, 31.4, 31.5, 31.6, 31.7, 32.1, 32.2, 32.3, and 32.4. For information about those fixes, see the release notes for the specific release.
| Defect Number | Description |
|---|---|
| General | |
| CFD-9524 | LACP port is not added to aggregator after flap in MLAG. |
| EXOS-32890 | The default FEC configuration is missing for some ports. |
| EXOS-32924 | The stacking link status and stacking link speeds are not correct when polled using OIDs 1.3.6.1.2.1.2.2.1 and 1.3.6.1.2.1.31.1.1. |
| EXOS-33022 | IP Address is returned in reverse order when IP-MIB is polled. |
| EXOS-33063 | There is a delay in displaying the output of the show ports forward-error-correction command for not-present ports. |
| EXOS-33197 | HAL process crash occurs after flapping BFD session. |
| EXOS-33290 | Local authentication failover doesn't work when using Chalet. |
| EXOS-33314 | STP fails to block loop when using Policy admin profile. |
| EXOS-33516 | The SNMP trap source IP address configured using SNMP set requests is not saved to the stack backup and is lost if the stack's primary node reboots. |
| EXOS-33619 | MLAG can be enabled on a cascade port in a VPEX+Stacking environment. |
| EXOS-33633 | Need support for RADIUS port bounce VSA. |
| EXOS-33657 | Error log needs to be displayed when OnePolicy ACL cannot be installed in the hardware. |
| EXOS-33676 | End client is accessible even though it fails netlogin authentication. |
| EXOS-33930 | 10203 FORMERICAOE optics flapping after changing link speed to 10G. |
| EXOS-33931 | An error occurs when enabling MACsec on the primary node of a stack. |
| EXOS-33934 | The following error message displays in the switch after restart:<Erro:cm.sys.LoadApplCfgObjFail> Slot-1: "exsshd" application failed to load "exsshdPrivKey" configuration object: Error reading SSH key. |
| ExtremeSwitching X435 Series Switches | |
| EXOS-30584 | Process jitterentropy-rngd causing high CPU in the ExtremeSwitching X435. |
| ExtremeSwitching X620 Series Switches | |
| EXOS-33540 | Failed to get phy temperature sensors for slot error occurs in the ExtremeSwitching X620. |