Open Defects
The following defects are open in this
release of the software.
| Parent Defect
ID: |
NPB-5182 |
Issue
ID: |
NPB-5182 |
| Severity: |
S2 - Major |
| Product: |
NPB |
Reported in
Release: |
NPB 21.1.1.0 |
| Symptom: |
Entity MIB item entPhysicalVendorType does not return any Vendor
type OIDs, instead it returns {0 0} when SNMP walk is performed.
|
| Condition: |
This issue is seen during SNMP walk of
entPhysicalVendorType in the entity MIB. |
| Workaround: |
No workaround |
| Recovery: |
No recovery available |
| Parent Defect
ID: |
NPB-5188 |
Issue
ID: |
NPB-5188 |
| Severity: |
S3 - Moderate |
| Product: |
NPB |
Reported in
Release: |
NPB 21.1.1.0 |
| Symptom: |
The Link Fault
Status field in the Show interface
ethernet command output may show incorrect fault
status. |
| Condition: |
no shutdown
on the ethernet interface. |
| Workaround: |
No workaround |
| Recovery: |
No functional impact |
| Parent Defect ID: |
NPB-5724 |
Issue ID: |
NPB-5724 |
| Severity: |
S3 - Moderate |
| Product: |
NPB |
Reported in Release: |
NPB 21.1.2.0 |
| Symptom: |
LACP port-channel remains down after replaying the
configuration with LACP rate as fast in the
member interfaces. |
| Condition: |
The issue is seen when the LACP configurations are
replayed with the node in default-configs. Only when
lacp rate fast is configured on
member ports.
|
| Workaround: |
Reboot the system with config or change lacp
rate normal and after the port-channel comes up again
change it to lacp rate fast on member
ports. |
| Recovery: |
Disable and enable LACP in the global config
mode.# no protocol lacp
# protocol lacp
|
