ip prefix-list 
 
   
  Configures an IP prefix list instance. 
 Syntax
 
	  
		ip prefix-list 
		 
		  name 
		   { [ 
		  deny 
		  ip-prefix/prefix-length 
		  | 
		  permit 
		  ip-prefix/prefix-length 
		  ] 
		  ge 
		  ge-value 
		  [ 
		  le 
		  le-value 
		  ] 
		  ] 
		  | 
		  seq 
		   sequence-number } 
		 
	 
 
	 
  
	 Parameters
 
		 
		   
			 -  
				 
				  name 
				 
			 
- Permitted values are between 1 and 32 characters. Although the first character must be alphabetic, the others can be alphanumeric, underscores (_) or minus signs (-). 
			 
-  
				 
				  deny 
				  ip-prefix/prefix-length 
				 
			 
- Denies a route specified in the prefix list.
						The prefix list matches only on the specified prefix and prefix length,
						unless you use the ge
						ge-value or le
						le-value parameters. 
-  
				 
				  permit 
				  ip-prefix/prefix-length 
				 
			 
- Permits a route specified in the prefix list.
						The prefix list matches only on the specified prefix and prefix length,
						unless you use the ge
						ge-value or le
						le-value parameters. 
							
								- ge
										ge-value
								
- Specifies the
									minimum prefix length to be match. The range is from ge-value to 32. 
- le
										le-value
								
- Specifies the
									maximum prefix length to be matched. The range is from the
										le-value to the prefix-length parameter. 
 
-  
				 
				  seq 
				  sequence-number 
				 
			 
- Specifies an IPv4 prefix list sequence
						number. If you do not specify a sequence number, the software numbers them
						in increments of 5, beginning with prefix list entry 5. The device
						interprets the prefix list entries in numerical order, beginning with the
						lowest sequence number. 
Modes
 
		Global configuration mode 
 
	 
 
	 Usage Guidelines
 
		Enter no ip prefix-list name to
				disable this feature. 
 
		The ge-value or
					le-value you
				specify must meet the following condition for prefix-length:
					ge-value <= le-value <= 32
 
		If you do not specify le-value ge
				ge-value or
					le
				le-value, the
				prefix list matches only on the exact prefix you specify with the ip-prefix/prefix-length parameter. 
 
	 
 Examples
 
	 
				This example denies routes on
					1.2.0.0/8, where the subnet mask length must be greater than or equal to 20 and
					less than or equal to 28, and permits routes on 10.1.0.0/16.  
 
		device# config
device(config)#
device(config)# ip prefix-list test deny 10.0.0.0/8 ge 20 le 28
device(config)# ip prefix-list test permit 10.1.0.0/16