WS-MBI-WALL-01 Mounting Bracket on Junction/Gang Box
The WS-MBI-WALL-01 can be
mounted on a junction/gang box, wall, or a solid ceiling. When mounting on a solid
ceiling, it is required that you use a Kensington lock or an equivalent lock.
WS-MBI-WALL-01 Bracket
To mount the WS-MBI-WALL-01 bracket on a junction or gang box:
- Put the center of the bracket as close as possible to the center of the box. Find two bracket holes that line up with the box screw holes. The bracket holes that you select should be on opposite sides of the center hole.
- Feed the LAN cable(s) from the box going through the semi-circular center hole of the bracket.
- Using the provided screw hardware, attach the bracket to the box using the two holes you identified previously. Tighten the screws to a torque of 9.0 inch-lbs.
- Attach the LAN cable(s) to the AP and push the remaining cable length(s) back into the box.
- Align the AP3825 mounting holes onto the two mounting circles and slide it down.
- (Required for ceiling installations) Attach a Kensington lock (or its equivalent) through the lower left tab and into the AP.