EXTREME-V2TRAP-MIB

This MIB defines the following Extreme-specific SNMPv2c traps generated by Extreme Networks devices.

Trap Comments

extremeHealthCheckFailed

CPU HealthCheck has failed.

extremeBgpM2PrefixReachedThreshold

This notification is generated when the number of prefixes received over this peer session reaches the threshold limit.

extremeBgpM2PrefixMaxExceeded

This notification is generated when the number of prefixes received over this peer session reaches the maximum configured limit.

extremeEapsStateChange

Send on master/transit nodes.

extremeEapsFailTimerExpFlagSet

This notification is generated when the EAPS domain fail timer expires for the first time, while its state is not in Fail state.

extremeEapsFailTimerExpFlagClear

This notification is generated when the EAPS domain fail timer expired flag is cleared.

extremeEapsLinkDownRingComplete

If a transit is in link-down state, and it receives a Health-Check-Pdu from the master indicating the ring is complete, there is some problem with the transit switch that has issued this trap message.

extremeEapsLastStatusChangeTime

Sent on master/transit nodes. Provides a general indication of a status change using a 10 second timer.

extremeEapsPortStatusChange

Sent on master/transit nodes.

extremeEapsConfigChange

Sent on master/transit nodes. This trap has a granularity of 30 seconds.

extremeEapsSharedPortStateChange

Sent on controller/partner nodes.

extremeEapsRootBlockerStatusChange

extremeOverheatNormal An overheat (return to) normal notification indicates that the on-board tempature sensor has reported a temperature that has returned to within the normal operating range from having been in an overheat (or overcold) condition. The temperature of the unit has sufficiently cooled to be below the maximum (or warmed to be above the minimum) of the normal operating range.