Resolved Issues in ExtremeXOS 16.1.3-Patch1-8
The following issues were resolved in ExtremeXOS 16.1.3-Patch1-8. ExtremeXOS 16.1.3-Patch1-8 includes all fixes up to and including ExtremeXOS 11.6.5.3, and earlier, ExtremeXOS 12.0.5, ExtremeXOS 12.1.7, ExtremeXOS 12.2.2-patch1-12, ExtremeXOS 12.3.6, ExtremeXOS 12.4.5, ExtremeXOS 12.5.5, ExtremeXOS 12.6.3, ExtremeXOS 12.6.5.2-Patch1-3, ExtremeXOS 12.7.1, ExtremeXOS 15.1.5.4-Patch1-9, ExtremeXOS 15.2.4.5-Patch1-5, ExtremeXOS 15.3.1.4-patch1-47, ExtremeXOS 15.3.5.2-patch1-10, ExtremeXOS 15.4.2.8, ExtremeXOS 15.5.5.2, ExtremeXOS 15.6.5, ExtremeXOS 15.7.3 and ExtremeXOS 16.1.3. For information about those fixes, see the release notes for the specific release.
CR Number | Description |
---|---|
General | |
xos0057212 | SNMP traps not sent after changing or saving configuration, even though respective traps are enabled. |
xos0058668 | After rebooting DHCPv6, client remains in rebooting state. |
xos0062444 | Kernel panic occurs in DoS protect-enabled switches when TCN SYN packets to port 80 are flooded to Management port. |
xos0063331 | VLAN IP address is unconfigured when modifying the VLAN name/port information from Chalet. |
xos0063429 | The output of the command show fan shows the fan status as empty after a hot re-seating of the fan module. |
xos0063995 | SNMP sysUpTime does not return correct value after failover. |
xos0064029 | Cannot delete prefixes for VLAN router advertisement messages after setting them. |
xos0064075 | The output of the show fan command shows fan status as "Failed" after hot re-seating a fan module. |
xos0064281 | In Chalet, switch inappropriately displays logs for user accounts under enhanced security mode. |
xos0064299 | The hal process ends unexpectedly after executing the command debug packet capture on. |
xos0064319 | Aggregated route is not transmitted to upstream neighbor when highest prefix route received from neighbor. |
xos0064395 | STP digest value gets changed when adding the port in VLAN or removing the port from VLAN. |
xos0064459 | Nettools process ends unexpectedly with signal 11 when processing router advertisement packets with DNSSL option. |
xos0064490 | After upgrading from ExtremeXOS 15.2 to later release, last installed dynamic ACL rule is given more priority than previously installed rules. |
xos0064519 | with MVR enabled on two VLANs IGMP report packets are looped if sent to all hosts group |
xos0064589 | While learning BGP routes, some routes are not getting installed in route table when deleting and re-adding the static route. |
xos0064651 | Master Switch Fabric Module (MSM)/slot information is missing from show log command output. |
xos0055541 | TACACS: On configuring shared secret key in encrypted form with characters "&" and "<" , the show configuration aaa output shows a different secret key from what was actually configured. |
xos0063842 | Packets are being flooded in both network and access VLAN ports after port flap. |
xos0064175 | Packets are not being forwarded after disabling/enabling LAG ports in VPWS. |
xos0064178 | Hardware entries not released on disabling of ports in a LAG connecting an L2VPN router to the MPLS core when L2VPN sharing is configured and in use. |
xos0064203 | Incorrect next hop is choosen by BGP route after port flap. |
xos0064326 | LACP flaps when the LAG port is added to vman, with the vman ether type same as LACP ether type |
xos0064357 | Out of sync between PIM and RTMgr process after introducing new best route. |
xos0064383 | In the show l2vpn detail command output, the "PW Tx Pkts" counters are not updated for VPWS sessions even though traffic is passing correctly. |
xos0064033 | In BlackDiamond X8 and Summit X670 series switches, traffic gets software forwarded after disabling/enabling members of a shared group and recreating the shared group after deletion. |
xos0064447 | Creation of user accounts through XML does not work. |
xos0064446 | Vulnerability CVE-2016-2108 Negative Zero. |
xos0064445 | Vulnerability CVE-2016-2107 AES-NI implementation in OpenSSL. |
xos0061187 | Vulnerability CVE-2015-2808 Bar Mitzvah TLS protocol and SSL protocol. |
SummitStack | |
xos0062484 | EPM process ends unexpectedly on master switch if image upgrade on a standby slot exceeds 30 minutes. |
xos0063743 | On SummitStacks, after a save, and then reboot, the master node does not reboot and the following error "Timed out - HAL is not responding" appears. |
Summit X670-G2 Series Switches | |
xos0064574 | In Summit X670-G2, IPMC cache entries are limited to 5,000 when the lookup key is changed from Source-Group-Vlan to Group-Vlan mode or vice versa. |
Summit X460 Series Switches | |
xos0061128 | Unsupported "VLAN mapping to VPLS" command option available. |