Note
When upgrading from ExtremeXOS 30.2 to ExtremeXOS 30.3, for Auto-peering, you must manually enable the dynamic VNET feature (see below command).
Dynamic VNET feature is enabled by default when you create Auto-peering in ExtremeXOS 30.3. However when using previously saved configuration files from ExtremeXOS 30.2, you must enable dynamic VNET manually. This is true even if you re-save the configuration with ExtremeXOS 30.3 installed.
Summit X670-G2, and ExtremeSwitching X465, X870, X690, X590 series switches.
configure virtual-network dynamic [on | off]
configure virtual-network vn_name name new_name
The output of the following show command displays whether automatic virtual network creation is turned on or off:
show virtual-network {vn_name | vxlan vni vni | [vlan vlan_name | vman vman_name]}
Print
this page
Email this topic
Feedback
View PDF
Download EPUB