Configure SNMPv2 Communities

Use this procedure to add or delete SNMPv2 Communities.

Choose from the following actions:
- Go to Configure > Sites and select a site to configure a SNMPv2 community for the switches associated with the site. Then, select the Advanced tab.
- Go to Administration > System to configure SNMPv3 users for the full ExtremeCloud IQ Controller environment. Then, select the Settings tab.
From the SNMP field drop-down list, select SNMPv2.

The SNMP Communities panel appears. If any communities have been configured, they are listed in tabular form.
Choose from the following actions:
- To delete an existing community, select the community in the list, then select Delete.
- To configure a new SNMP community, select Add. Proceed to the next step.
  Note
  You can add a SNMP community from the Configure > Sites > Advanced workbench only.

Configure SNMP Community parameters as described in SNMP Community Parameters.

Table 1. SNMP Community Parameters
Parameter	Description
Name	Assign a name to the SNMP community.
Access Level	Choose an access level from the drop-down list. Options are: Read — Private Community. Default community for read-only SNMP communication. Write — Public Community. Default community for write SNMP communication. Available for full ExtremeCloud IQ Controller environment support only.