Pole Mounting AP-8163 using Extension Arms
To use the extension arm with the mounting hardware kit:
- Attach the pole mount section at the desired
mounting location using a U-bolt or band clamps.
- Complete the steps for assembling and positioning the mounting bracket sections
for poles less than or greater than 3 inches. See Vertical Pole Mount.
- Using a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench,
attach the extension arm to the Access Point bracket section with four M6 hex
flange screws. The two oval holes must be positioned on the short sides of the
Access Point. Tighten the hex flange screws to 60 inch pounds (lbf-in) the
unit.
- With the Access Point positioned so the gore vent is facing down, attach the
extension arm to the Access Point bracket section with two 1/2 inch bolts and
nuts. Tighten the nuts to 300 inch pounds (lbf-in).
AP-8163 Mounting Hardware Band Clamps