Sets MAC Security (MACsec) mode or half-duplex mode on ports 25–48 on Summit X460-G2-24p-24hp, X460-G2-24t-24ht switches.
hw-mode | Set the mutually exclusive hardware mode to MACsec or half-duplex. |
ports | Specify ports to configure. |
port_list | List of ports to configure. |
macsec-mode | Enable MACsec mode on the defined port list. |
half-duplex-mode | Enable half-duplex mode on the defined port list (Default). |
Half-duplex mode is the default.
This command sets the mutually exclusive modes for MACsec or half-duplex behavior on Summit X460-G2-24p-24hp, X460-G2-24t-24ht switches. To use MACsec, you must enable MACsec mode on these switches, since half-duplex mode is the default mode.
To configure half-duplex mode, you must remove any MACsec configuration from the specified ports. To configure MACsec mode, you must remove any half-duplex configuration from the specified ports.
You must save and reboot for this command to take effect.
To view your current mode setting, use the show macsec command.
# configure macsec hw-mode ports 25 macsec-mode
This command was first available in ExtremeXOS 30.1.
This command is available on the following platforms.
Note
The MACsec feature requires the installation of the MAC Security feature pack license.Platform | Ports |
---|---|
Summit X460-G2-24p-24hp, X460-G2-24t-24ht switches | Half-duplex, 1G ports (25–48) |