The following issues were resolved in ExtremeXOS 21.1.1-Patch1-2. ExtremeXOS 21.1.1-Patch1-2 includes all fixes up to and including ExtremeXOS 11.6.5.3, and earlier, ExtremeXOS 12.0.5, ExtremeXOS 12.1.7, ExtremeXOS 12.2.2-patch1-12, ExtremeXOS 12.3.6, ExtremeXOS 12.4.5, ExtremeXOS 12.5.5, ExtremeXOS 12.6.3, ExtremeXOS 12.6.5, ExtremeXOS 12.7.1, ExtremeXOS 15.1.5, ExtremeXOS 15.2.4, ExtremeXOS 15.3.3, ExtremeXOS 15.4.1, ExtremeXOS 15.5.1, ExtremeXOS 15.5.2, ExtremeXOS 15.6.1, ExtremeXOS 15.6.2, ExtremeXOS 15.7.1, and ExtremeXOS 16.1.3. For information about those fixes, see the release notes for the specific release.
Resolved Issues, Platform-Specific, and Feature Change Requests (CRs) in ExtremeXOS 21.1.1-Patch1-2
| CR Number | Description |
|---|---|
| General | |
| xos0061745 | Ampersand used in UPM script is replaced by “& amp” in the XSF configuration. |
| xos0062850 | When upgrading ExtremeXOS to 15.7 or later releases, the web HTTP access is enabled even though it is disabled in the configuration. |
| xos0063028 | RADIUS configuration with shared-secret of 32 character is lost after reboot. |
| xos0063082 | Updated DSCP value is not refreshed for Dynamic ACLs. |
| xos0063186 | Kernel oops occurs when deleting private VLAN. |
| xos0063282 | ExtremeXOS CLI restricts PVLAN subscriber VLAN from being configured as an EAPS-protected VLAN. |
| xos0063423 | Memory leak occurs in ISIS process when exporting OSPF routes to ISIS. |
| xos0063465 | Cannot add/delete ports to load-shared MLAG ports without disabling MLAG. |
| xos0063484 | Enhancement added in STP flush generation mechanism to reduce hardware programming load. |
| xos0063495 | Policy authentication fails when RADIUS request queue has stale entries. |
| xos0063614 | Kernel crash occurs when receiving DHCP packets with invalid field values. |
| xos0063710 | Kernel oops occurs on switch with Private VLAN and MLAG configuration after executing restart ports all. |
| xos0063736 | In Syslog, username information appears as "*****" during login/logout cases. |
| xos0063761 | Traffic is not forwarded after disable/enable sharing when traffic ingressing port is part of both port specific tag (PSTag) and service VMAN (untagged port). |
| xos0063791 | Disabling MLAG ports on both MLAG peer switches prior to VM migration prevents proper VXLAN termination. |
| xos0063853 | Potential memory corruption when MAC locking is configured. |
| xos0063870 | Kernel oops occurs due to memory overrun in user kernel interface. |
| xos0063956 | ACL slice is not freed up after changing IGMP snooping filter from per-VLAN to per-port mode. |
| xos0063967 | XNV dynamic VLAN is not created on MLAG peer where MLAG port is down. |
| xos0063968 | HAL process ends unexpectedly after changing/reverting service VLAN tag. |
| xos0064067 | Traffic loss occurs in MLAG setup when ingress port and ISC port reside on different hardware units, and when the internal port number for both of these ports is the same. |
| xos0063948 | Clearflow delta values are randomly not calculated properly. |
| xos0063463 | Static FDB created on PSTag VLAN port is incorrectly displayed in show configuration command. |
| xos0063494 | OSPFv3 process ends unexpectedly on BFD-enabled switches, if there are frequent link flaps for a long duration. |
| xos0063814 | UPM process ends unexpectedly with Signal 11 occasionally when UPM timers are configured. |
| xos0063849 | VXLAN: The commands disable ospf and disable OSPF vxlan-extensions does not flush learned RTEPs. |
| xos0064045 | Need support for tagged and untagged VXLAN tenant VLANs on the same port. |
| xos0064122 | The command show tech-support terminates prematurely when 40G or 100G optics are present in the switch. |
| xos0061506 | In Summit X440-G2 and X460-G2 series switches, the combo port comes up as active even though when link peer port is down. |
| xos0063872 | After multiple executions of run failover with redirect-flow configuration, IPv4 ping fails. |
| xos0063928 | Sysuptime in sFlow packets is invalid. |
| Summit X460-G2 Series Switches | |
| xos0063927 | Error "Deferred L2 notification code out of sync unit 0" repeatedly appears in log. |
| Summit X670-G2 Series Switches | |
| xos0063807 | On Summit X670-G2 series switches, egress ACL rule actions do not take effect on ports 64-72. |
| SummitStack | |
| xos0061777 | Standby nodes do not come back up to operational state after they go into failed state. |
| xos0062700 | When upgrading from ExtremeXOS 15.7 or earlier to 16.1, image download fails if image was installed in backup node first and master node second. |
| xos0063904 | FDB process ends unexpectedly in backup node of SummitStack configured as MLAG peer when certain FDB entries are not flushed properly after age-out. |
Print
this page
Email this topic
Feedback
View PDF
Download EPUB