Firmware Update Needed for ExtremeSwitching X465 Series Switches

If you have purchased an ExtremeSwitching X465 series switch, it may need to have the firmware updated. To determine if you need to update the switch, do one of the following:

Check the log by using the command show log match firmware and look for the following EMS message:

<Warn:HAL.Card.Warning> Switch CPLD firmware is out of date, do 'install firmware' to update.
<Warn:HAL.Card.Warning> Switch FPGA firmware is out of date, do 'install firmware' to update.

View the firmware version on the switch by using the command show version detail:

# show version detail
Switch          : 800908-00-02 1907F-10008 Rev 02 BootROM: N/A        IMG: 30.4.1.1  
                  FPGA: 1.2.41 CPLD: 1.1.18 VPLD: 1.1.13
VIM5-4XE-1      : 800910-01-04 1845F-10084 Rev 04
XN-SSD-001-120-1: 800954-00-02 1917F-10064 Rev 02

Image   : ExtremeXOS version 30.4.1.1 by release-manager
          on Sat Nov 9 10:30:47 EST 2019
Diagnostics : 1.1.10
Certified Version : EXOS Linux 4.14.123, FIPS fips-ecp-2.0.16

Build Tools Version : exos-x32-sdk-2.5.3.1.0

The current versions should be FPGA 1.2.41 and CPLD 1.1.18. If you have a VIM installed, the current version is VIM PLD 1.1.13.

If the firmware is out of date, run the install firmware {force} {slot slot-number} command to update the firmware. Running the update can take three to four minutes. Reboot the switch after updating it to activate the firmware.