Firmware Update Needed for ExtremeSwitching X465 Series Switches

ExtremeXOS 30.7 includes an update to the ExtremeSwitching X465 series switches FPGA firmware (version 1.2.42) to remove errors that might appear when hot plugging a fan module (see defect EXOS-18535 in the topic Resolved Issues in ExtremeXOS 30.7.

To upgrade, do one of the following:

When installing ExtremeXOS 30.7, accept the firmware upgrade when prompted (see example below).
After ExtremeXOS 30.7 is installed, run the CLI command install firmware.

To verify the new FPGA version is installed correctly, run the command show version detail:

X465-24XE.1 # show version detail
Switch          : 800974-01-AG 1924F-10492 Rev AG BootROM: N/A        IMG: 30.7.0.544
                  FPGA: 1.2.42 CPLD: 1.1.18 PPLD0: 1.1.8 PPLD1: 1.1.8 VPLD: 1.1.13

Example of Upgrading FPGA Firmware When Installing ExtremeXOS 30.7

X465-24XE.10 # download image 10.68.9.32 rmgr/onie-30.7.0.544.xos
Note: The inactive partition (secondary) will be used for installation.
Do you want to install image after downloading? (y - yes, n - no, <cr> - cancel) Yes
 
Downloading to Switch................................................................................................................................................................................................................
This image will be used only after rebooting the switch!
Installing to secondary partition!
 
Installing to Switch......................................................................
Image installed successfully
Installing FPGA/PLD image(s).  Do you want to continue?
(y - yes, n - no, <cr> - cancel) Yes
Installing firmware...
.......................................................................................................................
 
Firmware image has been updated successfully.
 
The FPGA/PLD image(s) were installed successfully
and will be activated upon the next system reboot.
 
This image will be used only after rebooting the switch!