The following issues were resolved in ExtremeXOS 32.2. Version 32.2 includes all fixes up to and including the following versions: 11.6.5.3 and earlier, 12.0.5, 12.1.7, 12.2.2-patch1-12, 12.3.6, 12.4.5, 12.5.5, 12.6.3, 12.6.5, 12.7.1, 15.1.5, 15.2.4, 15.3.3, 15.4.1, 15.5.1, 15.5.2, 15.6.1, 15.6.2, 15.7.1, 16.1, 16.1.2, 16.1.3, 21.1, 22.1, 22.2, 22.3, 22.4, 22.5, 22.6, 30.1, 30.2, 30.3, 30.4, 30.5, 30.6, 30.7, 31.1, 31.2, 31.3, 31.4, 31.5, 31.6, 31.7, and 32.1. For information about those fixes, see the release notes for the specific release.
| Defect Number | Description |
|---|---|
| General | |
| EXOS-31439 | Turning autopolarity off might not take effect on a port running at 10Mbps or 100Mbps. |
| EXOS-31666 | ezspantree.py stops functioning after a certain amount of run time. |
| EXOS-31670 | UDP profile doesn't forward traffic to /30 network if the switch interface has the same network configured. |
| EXOS-31700 | Access VLAN traffic is not forwarded over MLAG port to networks VLAN. |
| EXOS-31742 | HTTPS Chalet login failure with the message soap error session failed when attempting to log in via the same tab. |
| EXOS-31949 | L3 Remote mirror not working properly. |
| EXOS-31998 | OnePolicy rule precedence order can be changed using a command from 30.2 and later. |
| EXOS-32015 | Temperature is incorrectly displayed in the show temperature command. |
| EXOS-32056 | The footer should be printed without consideration of CLI paging. |
| EXOS-32259 | Switch sends overheat condition as an SNMPv1 trap despite MIB files denying it as SNMPv2. |
| EXOS-32288 | LLDP MED application configuration is removed from the port if the port is removed from the VLAN. |
| Extended Edge Switching | |
| EXOS-31638 | ExtremeXOS should throw an error to disable SLPP before configuring VPEX when it was enabled. |
| ExtremeSwitching X440-G2 Series Switches | |
| EXOS-31613 | Switch does not respond to system API calls and the CPU stays high for HAL and EXPY processes. |
| ExtremeSwitching X435 Series Switches | |
| EXOS-31362 | ExtremeSwitching X435 switch inline-power goes into the disabled state until the switch is factory reset. |
| ExtremeSwitching X870 Series Switches | |
| EXOS-31971 | VLAN-based mirroring stops working if any port on the switch is partitioned. |
| SummitStack | |
| EXOS-32335 | SLPP configurations are removed from the port but retained in the configuration when sharing on the port is disabled. |