The following defects are closed without code changes in ExtremeCloud Orchestrator 3.4.0.
| Parent Defect ID: | XCO-5263 | Issue ID: | XCO-5263 |
|---|---|---|---|
| Reason Code: | Already Reported | ||
| Product: | XCO | Reported in Release: | EFA 3.1.0 |
| Symptom: | Failed to report telemetry not streamed from device | ||
| Condition: | When SLX device is discovered from XCO and statistics are getting streamed using telemetry service. Device is not sending statistics using telemetry service. | ||
| Workaround: | Select the individual device and verify the statistics are streaming from device. | ||
| Parent Defect ID: | XCO-8072 | Issue ID: | XCO-8072 |
|---|---|---|---|
| Reason Code: | Insufficient Information | ||
| Product: | XCO | Reported in Release: | XCO 3.3.0 |
| Symptom: | When configuring an OOB QoS map of traffic-class-cos type without DP value provided on SLX, after device update, the entry showed up on EFA with DP value of 4. | ||
| Condition: | When configuring an OOB QoS map of traffic-class-cos type without DP value provided on SLX, after device update, the entry showed up on EFA with DP value of 4. | ||
| Workaround: | No workaround for this OOB entry. | ||
| Recovery: | Delete this OOB entry from SLX device side. | ||
| Parent Defect ID: | XCO-8131 | Issue ID: | XCO-8131 |
|---|---|---|---|
| Reason Code: | Not a Software Defect | ||
| Product: | XCO | Reported in Release: | XCO 3.2.0 |
| Symptom: | RMA command giving the error in EFA | ||
| Condition: | RMA command giving the error in EFA | ||
| Workaround: | After replacing with new device use same port pairs connection which were used before replacement and also If ports are in shutdown state, bring the ports up and re-run RMA. | ||
| Recovery: | After replacing with new device use same port pairs connection which were used before replacement and also If ports are in shutdown state, bring the ports up and re-run RMA. | ||
| Parent Defect ID: | XCO-8403 | Issue ID: | XCO-8403 |
|---|---|---|---|
| Reason Code: | Already Reported | ||
| Product: | XCO | Reported in Release: | XCO 3.2.1 |
| Symptom: | When adding SLX devices to fabric with add-bulk it fails | ||
| Condition: | Add SLX 8820 device(while keeping all ports admin down) to fabric using add-bulk command and see if it fails | ||
| Workaround: | Upgrade to 3.3.0 or above to have "auto admin enable feature" support for SLX 8820 device or enable all ports admin up and the try to add to fabric using add-bulk | ||
| Recovery: | Upgrade to 3.3.0 or above to have "auto admin enable feature" support for SLX 8820 device or enable all ports admin up and the try to add to fabric using add-bulk | ||
| Parent Defect ID: | XCO-8423 | Issue ID: | XCO-8423 |
|---|---|---|---|
| Reason Code: | Not Applicable | ||
| Product: | XCO | Reported in Release: | XCO 3.2.1 |
| Symptom: | Disk high usage and EFA is down on standby TPVM | ||
| Workaround: | efactl clean commands is used to clean up the disk. | ||
| Recovery: | efactl clean commands is used to clean up the disk. | ||