router/mpls/ldp
Configures the Label Distribution Protocol (LDP).
Usage
<mpls-config xmlns="urn:brocade.com:mgmt:brocade-mpls">
<router>
<mpls>
<mpls-cmds-holder>
<ldp/>
</mpls-cmds-holder>
</mpls>
</router>
</mpls-config>
Parameters
- ldp-session-ip
- Specifies the LDP peer ip address.
- ldp-targeted-peer-ip
- Specifies the peer IP Address.
- load-sharing
- Specifies the number of load-sharing paths.
- hello-interval-link
- In seconds (1-32767, default 5).
- hello-interval-target
- In seconds (1-32767, default 15).
- hello-timeout-link
- In seconds (2-65535, default 15).
- hello-timeout-target
- In seconds (2-65535, default 45).
- ka-interval
- In seconds (1-65535 default 6).
- ka-int-count
- In seconds (1-65535 default 6).
- ka-timeout
- In seconds (1-65535).
- filter-fec-in
- Apply filtering on inbound FECs.
- filter-fec-out
- Apply filtering on inbound FECs.
- advertise-fec
- In seconds (1-65535).
- lsr-id
- IP address to be used as LSR id for LDP.
- filter-fec-out
- Apply filtering on outbound FECs.
- rx-label-silence-timer
- Specifies the receive label silence time (100-60000 ms). The default is 1000.
- key
- Enables TCP-MD5 authentication.
- rx-label-silence-timer
- Specifies the receive label silence time (100-60000 ms). The default value is 1000.
- max-neighbor-reconnect-time
- Specifies the maximum time to wait for neighbor to reconnect (60-300 sec). The default value is 120.
- max-neighbor-recovery-time
- Specifies the maximum time to wait for neighbor to recover (60-3600 sec). The default value is 120.
- reconnect-time
- Specifies the session reconnect time (60-300 sec). The default value is 120.
- recovery-time
- Recovery time (60-3600 sec). The default value is 120.
- tx-label-silence-timer
- Specifies the transmit label silence timer (100-60000 msec).The default value is 1000.
- notification-timer
- Specifies the notification timer (100-120000 msec). The default value is 60000.
- tunnel-metric
- Specifies the LDP tunnel metric value (1-65535; default 0).
- label-withdrawal-delay
- Specifies the label withdrawal delay. The range is from 0 to 300. The default value is 60.
