cluster-client auto

Configures a Multi-Chassis Trunking (MCT) client for a cluster in auto mode.

Syntax

cluster-client { <NUMBER:1-1000> | auto}

no cluster-client

Parameters

Number: The user can use any client ID between 1 to 1000.
auto: Client ID will be derived as 1000+Port-channel number.

Modes

Port-channel mode.

Usage Guidelines

On both MCT nodes, you must configure the same client ID (either auto/client-id). The no form of the command removes the client from the MCT cluster configuration.

Examples

The following example configures a cluster-client auto.

device# configure terminal
device(config)# interface Port-channel 10
device(config-Port-channel-10)#cluster-client auto
          (or)
device# configure terminal
device(config)# interface Port-channel 30
device(config-Port-channel-30)# cluster-client 325

Example

device# show cluster
Cluster c1
================
Cluster State: Active
Bringup Delay: 90 seconds
Configured Member Vlan Range: All
Active Member Vlan Range: 1
Configured Member BD Range: All
Active Member BD Range: 501
No. of Clients: 2
Peer Info:
==========
Peer IP: 4.1.1.10, State: Up
Peer Interface: Ethernet 0/4, Source IP: 4.1.1.11
Keep-Alive:
==========
IP: 10.24.8.220, State: Up
Interface: Management 0 (mgmt-vrf), Source IP: 10.24.8.221
Client-Isolation Role: Primary

Example

Client Info:
============
Interface               Id               Description          Local/Remote State   Exceptions          
 ---------               --               -----------          ------------------   ----------          
Port-channel 10         1010                                   Up/Up
Port-channel 30         325                                    Up/Up     
PW                      34816                                  Up/Up