-
Enter
configure terminal to access global configuration mode.
device# configure terminal
-
Enter the
ip access-list standard command to create the access list.
device(config)# ip access-list standard stdACL3
-
Enter rules, specifying the needed parameters.
device(conf-ipacl-std)# seq 5 permit host 10.20.33.4
device(conf-ipacl-std)# seq 15 deny any
-
Apply the ACL that you created to the appropriate interface.
Example
The following example shows how to create
a standard IPv4 ACL, define rules for it, and apply the ACL to an interface.
device# configure
device(config)# ip access-list standard stdACL3
device(conf-ipacl-std)# seq 5 permit host 10.20.33.4
device(conf-ipacl-std)# seq 10 permit 20.20.33.5
device(conf-ipacl-std)# seq 15 deny any
device(conf-ipacl-std)# exit
device(config)# interface ethernet 5/2
device(conf-if-eth-5/2)# ip access-group stdACL3 in