You can display the following information about the port MAC security feature:
To display the port MAC security configured on a particular interface, enter the following command:
device# configure terminal device(config)# interface Ethernet 3/2 device(conf-if-eth-3/2)# do show run interface Ethernet 3/2 interface Ethernet 3/2 switchport switchport mode trunk switchport port-security switchport port-security max 10 switchport port-security mac-address 3200.1110.0002 vlan 250 switchport trunk allowed vlan add 250 switchport trunk tag native-vlan no shutdown
To display the port MAC security configuration details across ports on the device, enter the following command:
device(conf-if-eth-3/2)# do show port-security Secure MaxSecureAddr CurrentAddr StaticSec Violated Action Sticky Port (count) (count) (count) Eth 3/2 10 0 1 No Shutdown No
To display the statistics of the port MAC security configured for an interface, enter the following command:
device(conf-if-eth-3/2)# do show port-security interface ethernet 3/2 Port Security : Enabled Port Status : Up Violation Mode : Shutdown Violated : No Sticky Enabled : No Maximum MAC addresses : 10 Total MAC addresses : 0 Configured MAC addresses : 1 Last violation time : Shutdown time (in Minutes) : 0
To list the secure MAC addresses configured on the device, enter the following command.
device(conf-if-eth-3/2)# do show port-security addresses Secure Mac Address Table ---------------------------------------------------------------- Vlan Mac-address Type Ports 250 3200.1110.0002 Secure-Static Eth 3/2